Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I'm trying to set up a VPN that maps all internal subnets to a single private IP for a remote hosted application. I'm on an ASA 5585X running 9.4.(4)16 and need some configuration assistance.
object network AppVendor-Network host 192.168....
I recently upgraded from WLC 4.2.207.0 to 6.0.199.0 (WiSM), and WCS 5.2.130.0 to 6.0.196.0. All my heatmaps that contain 1231G LAPs are solid "maroon" (-35 dBm) in color. If I remove the 1231 APs from the heatmap selection on the right hand side, my ...
We have outsourced our HR application to the vendor to host at their data center. Configuring the tunnel and restricting access is not a problem. What is the best way to allow over 1,500 internal hosts on over 100 different subnets through the VPN tu...
I didn't run packet tracer twice, thanks for reminding me!
Ran the second time with an active SA and result was allow.
They finally put me in touch with their VPN engineer and he did not understand that we were using PAT. They opened up their side an...
I did that and when I initiate a constant ping it creates an SA.
I did a packet capture and the packets are not leaving the outside interface.
I don't think the dynamic PAT is working, I must be missing something.
Crypto map tag: outside_map, seq n...
My issue is with switches. PI is sending the username "enable" for telnet/ssh credentials instead of the credentials I specify. I'm only having problems with older 2950 series switches which are on the hardware compatibility list with a supported sof...