Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to setup a router within a district with VLANs and a /23 network.I have been given a 172.17.25.0/29 address to use.I have configured the 3560 SW Version:* 1 52 WS-C3560G-48PS 12.2(55)SE7 C3560-IPBASEK9-MI have ip routing turned on and VLA...
I was having an issue with a c2960x with corrupted IOS.
I formatted the flash and not I can not copy a new IOS to the switch.
I am at a switch: prompt
I ran flash_init and received it was already loaded.
I ran set BAUD 115200 and configured HyperTerm...
I have a stack on 5 C2960x-48LPD-L.
I am in a network of /16, /24, and /23
I am configuring the stack on a /23
I have a VLAN setup on the router with the /23 and the same on the stack
I can get to the Stack by the vlan on the router but not directly....
The eigrp setting helped with the routing but everything is going through VLAN 1. I am able to get IP Address from the DHCP settings per VLAN3-7 but it is not routing that traffic. If I get a DHCP address from DCSD-LAN pool which is 10.41.0.1/23 it ...
I am trying to move to a /23 but still have the /16 up and running. I swap the uplink while testing so I am not bring the network down complete until I have a valid connection. once done I have a lot of work due to the current tech has everything wit...
I had VLAN 2 setup with the address of 10.41.0.1 /23 and since it is currently in use at the Provider as a /16 i changed it to the 1.1/23 to see if it was an issue.
The current configuration has the network on a /16 with the provider having 10.41.0....
The first 2 line are what I have been adding to all setups i have done with a different address.
the 172.17.25.1 is the gateway of last resort
the 4th line is next hop from this router.
The 172.17.25.0/29 is the network I was told to use for setting...
