Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I need to setup my 6509 with PBR going to two different Firewalls. The 6509 has vlans and multiple serial interfaces. What/where do I install the policy-maps? I want to direct one of the vlans to one firewall and the other vlans and wan subnets to th...
I have two ISPs. Each is on it's own subnet connected to the 6509 MSFC/Switch. FW1 is on 100.1.100.0/30 and FW2 is on 200.1.200.0/30 subnet.My goal is route all traffice going to the Internet from subnet 10.133.3.0/24 to FW1 and all other subnets acr...
I have a hybrid environment and I will do my best to explain:OPTEMAN: 3 routers connected via a private subnet (/29) over the OPTEMAN: Site A, Site B, and HQ. Site A is a 3560 that is the gateway for two subnets: siteA1 and siteA2. SiteB is a 2621, a...
I am configuring PPP Multipoint on a 6509 and a 2621Here is the output of sh ppp multilink on the 6509:No active bundlesMultilink1 (inactive) Member links: 3 Se8/0/0:0 (inactive) Se8/0/1:0 (inactive) Se8/0/2:0 (inactive)Here is the output o...
I have to bond 3 T1s between a Cisco 2620 router and a Cisco 6509 (MSFC w/ FlexWan Module).At another site I have to bond 2 T1s to the same 6509.Any assistance will be helpful.Thanks
ok, I know I am struggling with this but I am confused about one line: Ip access-list ext 150deny ip 10.133.3.0/24 is not a Cisco option..... so should the line look like this: deny ip 10.133.3.0/24 10.133.2.0/24 10.133.1.0/24 10.133.4.0/23 ?
so let me understand this:the deny rule in the acl tells the policy to allow traffic from the other subnets?for configuration sake what would I put for: ??
