About j.joe

j.joe · 08-09-2006

I was using 3560 as a routing switch. From time to time, my wks cannot access outside the subnet. When checking the arp table on my wks, I found the mac address of the 3560 was wrong. I can clear the arp cache in the switch and make my wks resumed...

j.joe · 11-04-2002

I have installed Aironet AP350 for every floors of my 3 level office.When using PC-based laptop with wi-fi built-in, there is no problem when carrying around my office.But when using Apple PowerBook with airport card, I can only work in a single floo...

j.joe · 10-31-2001

Dear all,Need your advise. I want to implement a VPN connection from client PC to PIX 515. My client PC is using PAT to access to the internet and I want my client PC to be able to access to internet and my VPN at the same time (split-tunnel??)Must...

j.joe · 10-26-2001

Hi all,If there is any example of show the IPSec connection from VPN Client 3.x to PIX 515 and authenticat from MS IAS ??

j.joe · 09-16-2001

After upgraded from v5.3 to v6.0, I found the following log messages:<166>Sep 14 2001 15:35:45: %PIX-6-106015: Deny TCP (no connection) from 192.168.140.63/139 to 192.168.140.61/1507 flags PSH ACK on interface inside<166>Sep 14 2001 15:35:48: %PIX-6...

j.joe · 08-10-2006

Hi,To update you that the problem has been fixed. There was an IP conflict which was also used by a firewall setup (but no function now) 2 years ago.Many thx for your assistance.

j.joe · 08-10-2006

Yes. Thanks for the help.I tracked this should be from Nokia device. There are some Nokia firewalls in other segment and I am cross-checking with their mac address. Will keep you posted.

j.joe · 08-10-2006

Just now, I have to manually map the static mac address for each wks/server to overcome this problem.

j.joe · 08-10-2006

1)Yes they (wks/servers only) are all pointing to a the same wrong mac address.2)Firewall and switch attached to it did not have such problem3)My connection like this:Internet -- PIX -- 3560 (LAN gateway in Server room) -- 2970 (office floor switch)

j.joe · 08-10-2006

Becoz in the console I can identify the mac address of the switch in the same subnet. And when my wks can talk to the switch, I can show and see its mac address was correct in the arp table of my wks. All wks point to the switch as default gateway....

Member Since	‎05-31-2001 11:10 AM
Date Last Visited	‎08-18-2017 03:50 AM
Posts	33

User Statistics

User Activity

Wks received wrong mac address

Apple Airport and Cisco Aironet AP350

VPN connection with split tunneling and PAT

Example of VPN Client 3.x connect through IPSec and IAS

Syslog message about inside interface of PIX

Re: Wks received wrong mac address

Re: Wks received wrong mac address

Re: Wks received wrong mac address

Re: Wks received wrong mac address

Re: Wks received wrong mac address