Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I'm looking for a server to run CUCM 8.6 for a test lab.This IBM x3250-M2 is on the Supported Servers List.Has any loaded CUCM on this hardard?Or can someone recommend a Hardware Plateform keeping the cost low?ThanksMatt
We have a Cisco 5510 with 2 IPSec Connection Profiles each using a different IAS for authentication.If we add another VPN profile we need another IAS.With Cisco ACS can it be configured for different VPN profiles from the same ASA 5510?Thanks...
I have just a licensing question.I have a router that was updated to IOS mainline 151-2.T1 to support SRST 8.1.telephony-service srst mode auto-provision none srst dn line-mode dual ip source-address <IP> port 2000Since the upgrade I can no longer te...
I have a 2801 Router /w PVDM-8 and 4port FXO card.When a call comes in from the PSTN and the phone is not answered it is transfer to Unity in a different region.0/2/2 g711ulaw n S_CONNECT FXOLS_CONNECTIf I change the codec to g...
OK... Here is the requirement for VPN.Each ASA Connection Profile requires a different windows group to authenicate.So can the ACS be configured to know about the different ASA Connection Profiles.?Thus assign the correct windows group using external...
It does when the bandwidth is set to G711 between sitesIt fails when the bandwidth is set to G729 between sitesI do not see the gateway ever move to G729... on the 2801 Router.sh voice call summaryThanksMatt
