Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I can't connect via ASDM 7.5(2) 153 to newly installed ASA 9.4(2)11. I can connect via https://host_ip/admin/exec/ sh ver or do any other command. I also get unable to connect to via ASDM with Java Web Start to run too? Running Java 8r111. I ...
When doing Frame Relay Traffic Shaping between two routers, if the following command is configured on the two routers interface support the DLCI"frame-relay adaptive-shaping becn"So this will enable the router receiving congestion to tell the distan...
When configuring auto-rp on two routers for the same group, which router will be the primary RP for the group? If you use the followings command on both routers, will the higher or lower IP address of the loopback be the primary, I can't seem to find...
Hi, I was handed 2 6506 as distribution interconnected with two 6513 for the access to help increase the server farm redundancy. Each 6513 has got connections from both 6506. I have one vlan that supports dual connected servers, one server connectio...
I get no error when I browser to the ASA management interface. My host is .123. I can run commands to the asa via the browser, https://192.168.61.21/admin/exec/sh ver, etc. When I try to run Cisco ASDM as Java Web Start application, I can start do...
Yes we plan on configuring redundancy between all 4 swithces. We are using the Supervisor Engine 720 too. I am still not sure if GLBP will work with just one vlan in this configuration?