Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am looking at my PIX interface counters to see if I have any problems on the interfaces. I notice that some of the interfaces have values in the No buffer, Overrun, Underrun and Dropped packets.I assume the dropped packets are those dropped due to ...
I have CW2000 LMS2.6 and have added my PIX Firewall to the DFM module. I constantly get unresponsive messages for the PIX interfaces due to icmp being dropped.Is there anyway to allow the icmp to the PIX interfaces or a way for DFM to not ping them b...
If I have a 100Mb full duplex link and it is transmitting at full capacity but receiving a negligible amount of traffic will DFM show this as being 50% utilised or 100%?You can see my quandary, what do I set my threshold to? If I leave it at 40% I co...
I have a Catalyst 6509 with supervisor 720-3B and IOS 12.2(17d)SXB10. I have installed a X6704 4 port 10Gb card in slot 1 and powered up the system. The X6704 is recognised but is powered off with a message stating that it is not supported. Using sho...
A small conundrum which I can't get my head around. can someone please help.I have a meshed layer 2 network with multiple vlans in my server farm connecting to two core routers. All these devices are running in 802.1d Spanning Tree.I want to migrate ...
I take it that the line 'max(ifInOctetsRate, ifOutOctetsRate)' in english is use the maximum of ifInOctetsRate OR ifOutOctetsRate?If so this is exactly how I would like it to work i.e. calculate the utilisation for either the transmit or recieve, whi...
I've removed the X6704 and inspected it. I cannot see any daughter card mouned on it, there is only the base card.I remember reading on the cisco website that if not specified the x6704 comes with the CFC card but I can't find reference to this now. ...
Hi Paresh,I don't think I have any of those cards. Using show module I have the following:Mod Ports Card Type Model Serial No.--- ----- -------------------------------------- ------------------ ----------- 1...
Thanks for your help Gents.I have managed to find a definitive answer to my question by much searching on the Cisco Website and comments made by yourselves.The definitive answer is:1. RSTP selectively sends 802.1D-configured BPDUs and topology change...
hi,Thanks for your reply.I've not tried what you have suggested because I resolved the problem myself before you posted it.They way I resolved it was to download the IOS-S208.zip file, extract the virtualsensor.xml file, rename this to .sdf and then ...
