Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Can anyone help please. I have a 2611 and simply want the router to fail over to the backup DSL link when the primary fails. The problem is the primary is connected to a media converter which then connects to a point to point wireless access point. W...
Guys am i missing a global config here? I have the following commands on my 2950aaa new-modelaaa authentication dot1x default group radiusradius-server host 154.4.10.1 auth-port 1812 string CiscoSwitchint fa0/1dot1x port-control autoeven if i put the...
Hi, i've heard briefly of this, Can someone please tell me how to configure it? searching the Cisco site for documentation is proving troublesome. Basically (and if i have this wrong please correct me) i want my clients to authenticate to a radius s...
Hi guys, I have a question that I’m sure will be an easy one. I have 2 routers connected via a Wireless link using media converters. This is set up as:Router A>media converter>Fibre to the access point>wireless>Fibre from the access point>media conve...
Hi guys, can someone please have a look at this ACL? its acting strange on my 3750. i have a port in vlan 10 (192.168.100.x)and the rest in vlan 1 (10.x.x.x). the 192.168.4.0 network is on another connected router without ACL's.access-list 120 deny i...
Thanks everyone, I'm hoping this is sorted. Basically the reason that sys-auth would not go in was because some of the ports were left dynamic. After i made them all switchport mode access it took the command and enforced dot1x, i then configured the...
Thanks but i have read this information. I dont want to enable 802.1x on trunk ports, but the dot1x system-auth-control command is global. All i want is to enable dot1x port control on the ports i select, it seems that i can only enable it globally w...
I would also like to see the resolution to this one, when i tried this in a test environment all the natting command did was put an additional alias address on the router interface, the ping replies i was getting were from the router not the server.
Thanks, please send to [email protected] found a dot1x system-auth-control global config command but when i use it it tells me all my ports must be in switchport mode access, i have trunk ports.
The way i do it is to telnet to the switch and do a sho mac add to get a list of all mac addresses attatched to the ports, i realise that this means you connecting to each switch individually so if anyone has a better solution?
