Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I have a campus network with 3 -tiers, access, distribution and core layer, I have few questions as follows:1) in order to preserve end-to-end QoS, do i need any QoS configuration at Core switch ? if i don't even enable "mls qos" or configure "tr...
I have an ip phone connected to Cat3550 with the following configuration:interface FastEthernet0/32 switchport access vlan 311 switchport mode access switchport voice vlan 299 cdp enableWhen the phone successfully gotten the ip address (from dhcp) fr...
I have a cat6509 configured to talk to Radius server (ACS), as I understood that the IP address used by Cat6k to talk to ACS is by using the nearest interface ip, can i explicitly specify the source address used by Cat6k in this case ? thanks in adva...
Hi, I'd like to undertand what is the usage of "DHCP-Snooping Host-Tracking Information Option", when will that be used ? is it advisable to configured ? If someone can share with an example, that will be very much appreciated.ThanksKY
Is there any way to test UDLD ? as it's operate at Layer 2, by disconnecting one core of fiber wouldn't be able to test that as in this case Layer 1 is down.Thanks Kok Yong
Hi, GuysThanks for the information.By the way, I have some more doubts to clear.At the distribution switch, where I have a downlink connection to Cisco 3500XL switch, may I have some suggestion whether the QoS configuration at the DS, both global and...
Hi, ThanksI guessed this is the one I'm looking for, but you have mentioned that if it's from Cat6k mgmt interface, then u can't specify it since this interface will be used to talk to Radius.However, as I'm having Cat6k with native IOS, hence it's g...
