Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
- Cisco Community
- :
- About ataylor
Stats
Member since
10-11-2017
5
Posts
0
Helpful
0
Solutions
05-29-2019
06:12 AM
Harold, Many thanks again, it's safe to say we won't be using NAT-PT. Really appreciate the input. Many thanks, Andy
... View more
05-28-2019
05:45 AM
Harold, Fully agree with you, it's for an unusual telco regulatory requirement in the middle east, and to be fair more of a 'tick in the box exercise'. I was only looking at this as a very tactical option to provide more time to plan out a dual-stack deployment, however, everything is pointing to scrapping this and going dual-stack day 1. I then became curious as to why the config wasn't working, more for my own curiosity but guess some things aren't worth spending too much time on. Many thanks and all the best, Andy
... View more
05-24-2019
11:35 AM
Has anybody configures dynamic/hide IPv4 to IPv6? I have a requirement for IPv4 only hosts to connect to IPv6 Internet sites, I originally tried to lab NAT-PT with DNS ALG. <IPv4 only host> --- <Cisco Router with NAT-PT> ---- IPv6 Internet NAT-PT DNS is ALG configured IPv6 NAT service for DNS IPv4 NAT works fine IPv6 from the router works fine From an IPv4 Linux host, the IPv4 NAT isn't working. Lab config: Inside interface: interface GigabitEthernet0/1 ip address 10.0.0.5 255.255.255.252 ip nat inside ip nat enable ip virtual-reassembly in duplex full speed auto media-type rj45 ipv6 nat ! Outside Interface: interface GigabitEthernet0/2 ip address dhcp ip nat outside ip nat enable ip virtual-reassembly in duplex full speed auto media-type rj45 ipv6 address <IPv6 address>/64 ipv6 enable ipv6 nat ! ipv6 route ::/0 <IPv6 G/W> ipv6 nat v4v6 source list 75 pool v6pool ipv6 nat v4v6 pool v6pool <IPv6 start address> <IPv6 end address> prefix-length 64 ipv6 nat v6v4 source<IPv6 address> <External IPv4 address> ipv6 nat prefix<IPv6 address>/96 This is a stop gap for an immediate requirement until we can get a proper Dual-Stack design and implementation in place. Any advice would be greatly appreciated.
... View more
Labels:
Created by
ataylor
in Application Centric Infrastructure
in Application Centric Infrastructure
05-04-2019
09:01 AM
05-04-2019
09:01 AM
More than a little worrying the ACI SDK has been abandoned as have any previous Python initiatives for ACI!
... View more
05-29-2019
Harold, Many thanks again, it's safe to say we won't be using NAT-PT.
Really appreciate the input.Ma...
05-28-2019
Harold, Fully agree with you, it's for an unusual telco regulatory
requirement in the middle east, a...
05-24-2019
Has anybody configures dynamic/hide IPv4 to IPv6? I have a requirement
for IPv4 only hosts to connec...
05-04-2019
More than a little worrying the ACI SDK has been abandoned as have any
previous Python initiatives f...
Public Statistics
| Date Registered | 10-11-2017 03:51 AM |
| Date Last Visited | 06-01-2019 04:00 AM |
| Total Messages Posted | 5 |
