Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
There are two things we are trying to accomplish here.1. We want traffic from Site A to go across the point to point, out to the internet through the pix and back.2. Also we would like everyone on the 192.168.10.x network to access the 192.168.20.x r...
We have a hub and spoke vpn setup with all Linksys 10/100 16-Port VPN Router RV016. There are routers in front of all branches configured as bridges and all tunnels are working fine except the one that has the Cisco 837 ADSL router in front. Is there...
I have setup a pix 501 with a basic PAT configuration which I have attached to this post. router: 192.168.101.254pix outside if: 192.168.110.150pix inside if: 10.1.1.1web server: 10.1.1.2 I have only one static address available to use on the outside...
I worked with Gene and we resolved this issue. We reset the configuration using the link below.Followed the section on "Reset the Switch When the Device Manager Is Not Available."http://www.cisco.com/en/US/products/ps6545/products_tech_note09186a0080...
