Hi, I have a mini test setup that I am attempting to setup to support testing of IP phone provisioning. The setup consists of a IP Phone, Windows 2008 and Cisco 3560 POE switch. On the switch I have created three VLAN'sVLAN 100 Native - 10.252.100.0/...
ScenarioNetwork consists of gateway router the have PABX's connected by either QSIG or E&M. Call control is via a H323 GK where each gateway registers using a tech prefix.A number of sites are low bandwidth 64K or 128K, to improve available bandwidt...
OFFICIALI have a windows 2008 Server where I have created a scope for native under 10.252.100.0/24 for a block of 10 addresses and I have done the same for voice under 10.252.200.0/24 again for a block of 10 addresses. Appreciate I can push VLAN from...
Hi Thanks for the response, for some reason it looks like the url for the white paper did not attach.Are you aware of any method that will take into account header compression ?Cheers
Hi,Thanks for your reply, just one question, is it possible to implement your suggestion if all different codec are selected using the same node id (tech prefix) e.g.Router Tech Prefix - 8560Pots Dial Peer 8560....Clear channel 85602000G728R8 ...
