Hi everyone, I have 2 PIX 515 (running 5.2(3)) setup for stateful redundancy (serial cable + ethernet4 crossover). I've had on occasion the following problem: the ACTive status switches between the two boxes, but communications thru the firewall sto...

Hello, I run a 6509 with a Sup1+MSFC2 in CatOS + IOS mode - I wish to upgrade the IOS image but the image is too big for the MSFC2's bootflash (even if the requirements ask for 16M, a 16M flash isnt big enough after formatting). Is it possible to u...

Is there a web page on cisco.com from which we can enter a switch's serial and see if its currently covered by a support contract ?Thanks!!

I'm having _one_ user that can't connect to a VPN3005 box.. from the same user's station, with the same vpn client (3.6.2b), we can connect with another user token/profile fine...The VPN3005 talks to a Cisco ACS 2.6 via TACACS+, which in turn talks t...

Hello all, Just wondering if the same type of support that exists for fixing up FTP when NAT is used also is available for RPC traffic ? IE a management station is trying to access a station via RPC, but the destination IP is a NAT.. I'd be surpris...