Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
As per all docs, multi-area OSPF reduces Link state database on a Internal Router.But if I don't configure summarization, Stub, Totally stub kind of features, then on a vanilla multi-area OSPF topology below will happen"Internal router will have less...
I have a setup like: - Dual Cisco distribution switches working on PVST+ and connected on dot1q trunk.A non Cisco access switch working on CST and connected to dual Cisco switches on access port making a triangle topology for redundancy.Since I don't...
Hi,In my scenario, I have two Core Layer 3 Switches. And there are few access switches connected to Dual Core switches redundantly. I want to make one Core Switch as HSRP Active for few VLANs and other Core Switch as HSRP Active for rest of the VLANs...
Hi,ASA 5505---DSL Router---Internet---ASA 5520I have a setup as shown above...I have a ASA 5505 connected to inside interface of my broadband DSL Router. ASA 5505 will have private IP on its inside & outside interface. Only DSL Router outside interf...
Hi Gaurav,Thanks for the update...In my case, though all the ports of non-cisco switch will be in VLAN 1 but they will have the IP Subnet of VLAN 100 range. The moment they hit the cisco switch they will be tagged VLAN 100 and will work normally. Thi...
Hi,I understand for a single switch forwarding all frames it won't create problem.But what about both Core switches forwarding frames for their individual active VLANs. In this case both core switches (connected to different ports of underlined acces...
Hi,Thanks for the update...Since HSRP Virtual MAC Address depends on the Standby group and using the same standby group will yield similiar MAC address for all the VLAN interfaces.So do you think this can create a problem when both the switches will ...
Hi,These are Dlink switches. But I am not sure of the models as these are present at my Customer site and I need to give them solution.But I hope mismatch of VLAN on access link can only be detected by CDP messages. Since CDP is Cisco Proprietary, so...
Hi Hoogen,Thanks for the immediate response...Had your scenario also was with Cisco and non-cisco switches??But in my case I might not be able to keep both sides of the access link in same VLAN. I will only configure Cisco side of the access port in ...
