Hi Please help.I have the following hardware / software2 x 3725 running 123.12 ipplus2 x NM-1T3/E3 network module.The router sees the card - during boot up and via a "show ver"But doing a "show run" does not provide any serial interface or a controll...

Hi AllI currently have the following issue with two Cisco 4006 switches that are connected by a GigabitEtherne trunk. Configured for dot1q trunking.See output below.sh int gigabitEthernet 1/1GigabitEthernet1/1 is up, line protocol is up Hardware is ...

HiI have the following setup.(sf1) (sf2) { ospf } { cloud } (rtrX) (rtrY) | | [fw1] [fw2] | | (rtr1) (rtr2) | | cct1 cct2 | | | | (rtr3)--(rtr4) | |------LAN1----- key---sfn ...