Hi
Please help.
I have the following hardware / software
2 x 3725 running 123.12 ipplus
2 x NM-1T3/E3 network module.
The router sees the card - during boot up and via a "show ver"
But doing a "show run" does not provide any serial interface or a controller to configure. What I'm I doing wrong.
I've looked on Cisco's web site and it says that 122-11T is the minimum software required.
I've tried this in both routers using both cards and I get the same results.
Does the 3725 support this card. The manual / web site says so.