Hi all,I have imported devices from a file to RME and tried synchronising the ANI to no avail. All services are running normally and the status log states that the synchronisation was successful with number of devices =0.Any ideas?
Hi Terry,What I found was that another service was using port 14004. I changed the ANIServer port in /opt/CSCOpx/campus/etc/cwsi/ANIServer.properties and restarted dmgtd and up it came.Hope this helps.Regards,Tania
I had a similar issue and found that the port the ANIServer uses (14004) was being used by another process. I changed the port and the ANIServer is up and running. However I still have the same problem when opening topology service - Cannot connect ...
