Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hello , I have configured the ATA on the callmanager. If i connect the Phone on the along port and make a incoming as well as outgoing call it works. Now i have connected the Fax machine to the port. and I m trying to send / recieve the fax from the ...
Hello , I have setup AP 1100 in the nw. data connectivity are working fine. Laptops are getting associated with AP. but when i m trying to associate the Wirelss phone 7920 its not getting associated. It gets authenticated.It shows association in prog...
hello , I have installed the Access point 1100. Laptop's are getting registered and i can brows the nw. but when i m trying to registered the 7920 phone its not getting registered. it shows ip address as 0.0.0.0 for while and the again start the regi...
Hello , I am using CM 3.3(3) and C6509 as a voice gateway with 2 E1 link terminated on the vioce gateway. is there is any way to trace incoming/outgoing calls on C6509 somthing like debug Q931 thanx
Hello , First some points need to be clear , 1. T1 link terminated on the 2621 has DID ? 2. U have put the calling party transformation mask at the route-pattern ? and external phone no mask as well ? 3. how many IP Phones u have on ur network ? one ...
simple config : ex:# conf tconf# voice-port 1/0/0conf(voice-port)#connection plar 1000 /* 1000 is the extion of the IP phone */then do dial-peer config dial-peer voice 100 voip destination-pattern 1...session target ipv4:1.1.1.1 codec g711ulaw regard...
Hello , i have few question , 1. U said caller phone no shows on the Called Party but not the Caller ID name. R u trying to send to NAME info. to the PSTN network user? ThanxAnand
Hello , Solution : change the System Name to IP address in the URL mentioned in Enterprise Parameter. this is happening coz of phones not able to resolve the system name to ip address. this is the alternate way out Thanx
hello , I have installed the Unity 4.0 on Win 2000 integrating with exchnage 5.5 which is on NT domain. The problem you are facing is due to the permission not getting set on the the three users which u have created. 1. Create the user on the domain...
