Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,Recently, the Cisco 9000 series switch is displaying logs below and has caused the interface to be suspended.The issue only affects up-links with SFP-10/25GBase-CSR modules which are patched via Multi-mode OM3 Fiber cabling with distances rang...
I'm currently facing an issue whereby the device was not able to delete from the inventory list on the APIC-EM server. It got stuck at the deleting devices bar for almost 1 hour. Even after refreshing the GUI page, the device is still listed on the i...
We have recently upgraded Cisco 3650 stack switch from 03.06.05E to 03.06.08.E. The switch was on install mode but we upgraded it using bundle mode. The switch was upgraded successfully but the member switch went into provisioned state.
We had to co...
Hi Guys,
I would need your suggestion on this particular case. I noticed there were some spikes on the CPU usage on the 3560 switch. The process that is causing these intermittent spikes is IP Host Track Pr. However, i'm not so sure what is this p...
Hi Guys,
We have a Cisco WS-C4500X-16 switch with a 2 Supervisors, one of the active supervisor has failed over and there are no relevant logs indicating why it failover to the standby. I have capture the following logs below. Currently, the standb...
You can actually create one IPSEC tunnel to 3rd party vendor on the hub mx and then create a static route to advertise the IPSEC remote subnets to the spokes mx/sites.
Thanks Elliot, but both interfaces are set to speed 25000 so it shouldn't receive the logs alarms unless the speeds value are different.Do you think both interfaces need to use the same type of SFP modules. That's the only difference i could see. I h...
Hi Tats, i'm currently facing the same issues as well. I went through a forum and noticed that disabling the NAT-T on the back-end of the Meraki should resolved this issue. https://community.meraki.com/t5/Security-SD-WAN/Third-party-site-to-site-vp...
