Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,Recently, the Cisco 9000 series switch is displaying logs below and has caused the interface to be suspended.The issue only affects up-links with SFP-10/25GBase-CSR modules which are patched via Multi-mode OM3 Fiber cabling with distances rang...
We have recently upgraded Cisco 3650 stack switch from 03.06.05E to 03.06.08.E. The switch was on install mode but we upgraded it using bundle mode. The switch was upgraded successfully but the member switch went into provisioned state.
We had to co...
Hi Guys,
We have a Cisco WS-C4500X-16 switch with a 2 Supervisors, one of the active supervisor has failed over and there are no relevant logs indicating why it failover to the standby. I have capture the following logs below. Currently, the standb...
You can actually create one IPSEC tunnel to 3rd party vendor on the hub mx and then create a static route to advertise the IPSEC remote subnets to the spokes mx/sites.
Thanks Elliot, but both interfaces are set to speed 25000 so it shouldn't receive the logs alarms unless the speeds value are different.Do you think both interfaces need to use the same type of SFP modules. That's the only difference i could see. I h...
Hi Tats, i'm currently facing the same issues as well. I went through a forum and noticed that disabling the NAT-T on the back-end of the Meraki should resolved this issue. https://community.meraki.com/t5/Security-SD-WAN/Third-party-site-to-site-vp...
