Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all.I didn't understand one thing about the WDS domain for the APs.I understood that I need LEAP to authenticate one AP into the WDS domain. But, after all APs are logged into the WDS, the WDS will make faster my EAP-TLS authentications too? My ne...
Hi all.I have a CISCO 1200-ABG used for 5 or 6 notebooks 11b. The problem is that the CISCO keeps loosing the transmition ramdomly. I used a software to monitor de signal strength and quality, and it's clear that, every 5 or 10 minutes, it doesn't tr...
I need to design a WLAN for 200 hosts. So, how many access points (will use 802.11b) I will need? How should I calculate this?And how should I configure them? They should be, each one, in a different channel, correct?
Well, I'm using 12 AP 1200 and all them works fine. I'm using 12.3(2)JA and the client request for a IP address sending a broadcast to the network, and the AP forward this to the Ethernet, in 8 different VLANs. I dont think it's a IOS problem.
I dont have the logs. But I remember it shows only "client has disassociated, etc", but nothing different and unusual. I'm not using any authentication or security. I was using WEP 128 but with this problem I disabled everything to try to make it wor...
I was thinking in put 3 AP 802.11g and the clients with 802.11b... i don't need high speed for the clients, but I need all of them connected with some good speed (1 or 2 Mbps is enough).What do you think? Will it work?
Hum... That's really a problem for me. The space there is "small"... Only 100 meters and have 160 machines... I was planning to use 5 access points. The machines are for Web Development, so, they don't need too much bandwidth. 50 machines are for Net...
