Hi, Before running firmware asa722-k8.bin and asdm-522.bin ASDM "asdm location" config lines were created when we created a network object. After the upgrade to asa722-k8.bin and asdm-522.bin this dissapeared. We recently upgraded to asa724-k8.bin an...
Hi,We've got a global NAT rulestatic (inside,outside) interior-192.168.0.0 interior-192.168 netmask 255.255.0.0 But now we need some dynamic policy NAT:access-list inside_nat_outbound line 1 extended permit ip 192.168.0.0 255.255.0.0 host 217.77.27.1...
Hi,I was wondering if cisco devices, routers, asa etc... can sync with an external NTP server and then also play for NTP server for other devices?Regards,
Hi,We've got some Vlans configured on our cisco 4006 chassis. We also have a L3 module who routes between the vlans.Now we're deploying new PC's with altiris through multicast.How can I forward multicast from one vlan to another?any suggestionsRegard...
Hi,We have some ATA's running with callmanager. Sometimes incoming faxes are not fully completed.We receive most of the time just a half page. Sending : same problemAudio mode is already on 12 for the fax port.any suggestions? (latest ATA firmware al...
Hi,Before running firmware asa722-k8.bin and asdm-522.bin ASDM "asdm location" config lines were created when we created a network object.After the upgrade to asa722-k8.bin and asdm-522.bin this dissapeared.We recently upgraded to asa724-k8.bin and ...
thx for the answers but I think I found the solution.I was working on an ASA that had the config of an old PIX.From the things I've read (I'am not a PIX/ASA expert) in the old version of PIX you need a NAT rule for all the traffic that to go through...
nat (inside) 1 access-list inside_nat_outbound tcp 0 0 udp 0 Maybe clarify some more.When the user need to access 217.77.27.188 (partner connection) they need te use a NAT pool (193.14.22.1-193.14.22.10)But the users also need to access the outside ...
Cisco and software : not a good partnershipif you ever worked with cisco works, CRS you now what I'am talking about.Wish I could help you, but if cisco can't ...