Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
In the phase of assessing a certain enterprise network that running OSPF, It was found that they have three of Area 0s as shown in the attached drawing.Having this, made an automatic network assessment tool to think that we have dis discontiguous a...
This case is about a DHCP setup where two DHCP servers are Located in VLAN 25 at site Y. Users in VLAN 12 at site X needs to get the dynamic IP addresses without specifying an IP address for a DCHP server. In MSFC-X, we had the following c...
Using CiscoWorks2000, What is the fastest way to get the capture of the running configuration for each discovered device.I do not to go for each device and use the "save as " since I have 100`s of devices.I am running CiscoWorks over Solaris.
I am deploying CW2K to a network. The network includes some Cisco workgroup switches those were installed without being configured with any IP address. Is there a away to use CW2K to have an inventory of all devices in the network including those swi...
This might not seem to be a smart question but "wrong" aa commands commands were pushed to 100`s of devices using RME Netconfig. The result was that no user is able to login to any of the devices.The aaa commands were not saved but the command snmp-s...
Actually, the network has 3 OSPF processes on some security purpose.My point is, If they need to have three OPSF processes through the network, they were to give them three different numbers (e.g OSPF 1,2 and 3.) rather than giving the same number to...
Thanx for Kevin and Rick.Actually, I expected so. I will proceed on forcing the DHCP server people to specify their IP addresess rather than using the broadcast address.
To cut the story short, I use the ip helper-address x.x.x.255 command for I want any DHCP server within the x.x.x.0 subnet to be working. I do not want to specify one or two IPaddresses for the DHCP servers.Still, I do not want any broadcast storms o...
Thanks Steve.I have already solved the problem using some 3rd party software (called SolarWinds) which uses CISCO-CONFIG-COPY MIB to download the congiuration edit it then upload it.Since I know the rw community string and have SNMP access to the dev...
