CW2K CDP Discovery

[yamaan]

I am deploying CW2K to a network. The network includes some Cisco workgroup switches those were installed without being configured with any IP address. Is there a away to use CW2K to have an inventory of all devices in the network including those switches those do not have any IP configured?

If not! Is there any other way rather than using CW2K (Ofcourse and not using show cdp neighbor detail)

[rmushtaq]

In order for CW2K to do the device discovery, the device must have ip address configured on it, SNMP community strings setup properly. If CDP is not enabled, then you'll need to add these devices as individual seed devices.