Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear AllI have a 4500 Switch with Two WS-X45-SUP7-E Supervisor Engines with IOS version: cat4500e-universalk9.SPA.03.02.02.SG.150-2.SG2.binWe keep receiving the below LOGs non-stop.002777: 002404: .Mar 4 05:56:17.840 DST: %PM-4-PORT_CONSISTENT: STAN...
Dear JosephI am having a very strange issue on LMS 3.2The problem is that the syslog collection suddently stops receiving logs and writing them into the syslog.log fileI have checked the following:- Packet sniff to make sure that logs are being rece...
Hi AllIf a PC had the the CSA Agent installed and working properly, but after a certain time it was formatted and the CSA agent was not installed again.Is there a way to detect that from the CSA-CM?Like can we detect/generate report of Agents that ha...
HiI have a setup were all users (LAN & WIRELESS) Are being authenticated using Dot1x with ACSIn case of ACS failure (without a secondary one), I know i can configure the switch port on the LAN to have a critical VLAN, so in case ACS was detected as D...
Hi AllI am doing MAB (MAC authentication bypass) for IP phones and printers.But these devices are authenticated with different identity stores (IP phones with AD, printer local host on ACS)Is there any specific AV Radius attributes that i can use in ...
Dear John,Is there any update about Qradar integration with ISE via PxGrid? If so, is there Any official documents, links that we can refer to?Regards, Georges
Hello There are normal users connected to them.We tried to switch user's ports and change cables, but the logs kept appearing from the same Ports --> So it's not a Cable or user PC issue.Thanks for your helpBest regards, Georges
HI JosephHave this been resloved in LMS v4.0.1?I have an ASA 5580 as a gateway for all users, Can we retrieve the ARP information from it in order to support User Tracking?Regards,Georges
Hi JosephDo you have any link/Document for a design and implemention of the design you stated above? "split the geographic regions across servers, where one server act as the master DCR, and share that with another server running another instance of ...
