About smithers_steve

smithers_steve · 09-17-2007

Hi,I have a provider that serves me a 100mb/s Ethernet port, Single VLAN, between two locations. They block important traffic to me like STP BPDU's, VTP etc..What technology can I use to take everything, STP, VLANs, Multicast etc.. and encapsulate it...

smithers_steve · 03-12-2012

Hello all,This post is a bit old but I found an answer elsewhere and figured I would post it. Hope this helps.The label operations are push, pop, swap, untagged and aggregate.Push - impose a label. Can be a new label on an new packet or an additional...

smithers_steve · 09-21-2007

Great reply. Thank you. I will try it over the weekend.Thanks again,Steve

smithers_steve · 09-21-2007

Thank you for the advice. Q-in-Q and L2 tunneling protocol at the same time?Q-in-Q for tagged traffic plus L2 tunneling protocol for traffic such as VTP, STP BPDU's etc..??Thank you.Steve

smithers_steve · 09-18-2007

Thank you for your response. What if they do not offer it or it is too expensive?Is there a method of encapsulating every packet, sending it on it's way formatted as L3 IP or L2 Ethernet to the other side and un-capsulating it there? I was thinking ...

smithers_steve · 02-11-2004

You need to apply the "match address" parameter under your crypto dynamic-map. I had the exact same problem as you and that fixed it for me. The link you listed shows how to do it. Here is a gotcha though - make sure you create the access list befo...

Member Since	‎02-11-2004 01:37 PM
Date Last Visited	‎08-18-2017 03:51 AM
Posts	6
Total Helpful Votes Received	1

User Statistics

User Activity

MPLS, VPLS, MAC-in-MAC Ideas for my application

What is mean of POP tag and Untagged in MPLS forwrding Table ?

Re: MPLS, VPLS, MAC-in-MAC Ideas for my application

Re: MPLS, VPLS, MAC-in-MAC Ideas for my application

Re: MPLS, VPLS, MAC-in-MAC Ideas for my application

Re: Strange issue with 3.6.3 VPN Client and IOS firewall