Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've been searching the forums to see if any other users have completed this type of configuration successfully with not much luck. I have a Cat 6509 currently in production. We have several Vlans and all communication and routing is funtional in o...
I have a Cisco WLC 5508 managing several 1252s in lightweight mode. There is a portable across campus that has a standalone network but no cabling to tie in to the corporate network. I have another 1252 that is in autonomous mode. Could I essentia...
Ok so I have a weird issues. We us a county facility as our ISP so to speak. Basically our WAN Router is connected over OPT-MAN to this facility. We have ACL's opened on the ASA to allow all traffic inbound/outbound to this facility. Everything w...
Ok so I got a complaint from our public agency which acts as our "ISP" that their IDS system detected a host(s)(in our network) showing malicious activity, connecting outbound to an Internet IP of 94.100.25.138 over port 4723. I did some research an...
I've configured a few of these in my time but I'm puzzled with this one. I can establish connect via VPN tunnel however I can't seem to ping or get out on the internet. I've searched the forum for similar issues and found a few but none of the fixe...
I think this article explains what i need, Stepen. Would yo agree?http://www.cisco.com/en/US/products/ps6366/products_configuration_example09186a0080905cea.shtml#diagRegards,Dee
Thanks for your response, Stephen. I'm a little familiar with WGB and have read how you can set up APs to be bridges etc. Considering that I have a WLC managing several Lightweight APs that make up a WLAN w/ WPA2 and a SSID, how would I implement W...
We are directly connected over "WAN" (router to router) to the facility over OPTMAN. All network resources are reachable end to end using private IPs. Ours - 10.16.x.x, there's 10.94.x.x. So just to reiterate if we launch the application i.e. ht...
Jennifer,Thank you for your response. I agree with you on the acl statements and neglected to remove those after testing. I've removed the acl in question however I want to reiterate we are getting to all resouces on the 10.94.x.x networks just fin...
