Hi All,
This discussion is about a DHCP client not receiving an ip address, below is the scenario,
Assumption: We have a host device which is a DHCP client A, R1/R2 are two L3 switches and R3 a DHCP Server.
Connectivity: DHCP C...
Hi All, If any of you have come across an issue of this sort, request your help here. I have configured a S2S VPN on ASA 5550 version 8.1(4) IOS. Everything works fine when I generate the traffic towards the customer end. I have configured th...
Mark as per the details given to me, this was earlier working with the same scope, and there were no changes done on to the scope part as such. But again better to have them confirmed by the team. Also there are 2 more routers above these di...
Hi Mark,
I was able to run the debugs and was able to find the below outputs as such, apart from it I did not see any return packets as such..
Dec 18 07:58:11.179 GMT: DHCPD: setting giaddr to 1x.xx.xx.xx4.Dec 18 07:58:11.179 GMT: DHCPD: BOOTRE...
Thanks Mark let me do the debug and check on the outputs. To answer the other question
You can ping the helper address from the vlan interface yes ? Yes
Also the design which I depicted above is not the actual design. The DHCP server is out on th...
Thanks Mark for the details, as such the client is connecting his device directly on to the device R2 on which one of the port is configured with the same vlan.
By any chance can you let me know any debug commands which can help me troubles...
Hi Ajay,
Thanks for the details above, I am using the same scenario or diagram which is shown above, but there is a slight change here, assumption is R1 is a host device and is directly connected to R3, both R2 and R3 are running HSRP in act...