Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Ok, I have what should be a fairly simple situation here, but I am unsure as to how *exactly* to do it. I have a CAT 4006, sup II engine that is presently acting only as a layer 2 switch. There is nothing fancy on it at all..... In fact, about the ...
We are upgrading from a 256k frame relay connection to a point to point T1. Router "A" is a 3620, Router "B" is is a 3660. Both are using T1-WIC-1-DSU cards. The original (frame relay) configurations are as follows:Router A interface Serial0/0 ban...
Hardware: 1604Problem: No data passing on Bri 0Background: This line is nailed up 24X7 and has been rock solid for a couple of years. Two days ago, it suddenly stopped working.Attempted corrective action: Went on site and rebooted. Did shut/no shu...
Ok, I'll be the first to confess I'm an idiot......I have to install a shot tomorrow, and left all the hardware at work. Today, I'm supposed to be going out and getting the masts. Without the "U" bolts on hand, what diameter mast should I be buying...
I have a 4700 that attaches to an LS1010 via a fiber connection. The connection suddenly ceased to pass data. I have changed out the fiber patch cords, tested the fiber backbone, both warm and cold booted both devices, etc.etc...... The interface ...
It works now.It was a combination of two things:1) Pulling a new wire for the extended dmarc got the "loss of signal" errors to go away so I could see alarms on the line.2) changing the encapsulation to hdlc and back to ppp finally ended up doing the...
Thanks, I tried that. I also tried inverting the data code, chaning the framing, changing the linecode, and everything else I could think of configuration related. I even changed the IP addresses to unnumbered just in case for some truly bizzare r...
Is this just a matter of issuing 'loopback local' checking the errors, then 'loopback remote' and checking the errors? Or is there something more to it?Thanks
Don, please let me thank you for all your help. It turned out to be the ISP. It took one of your replys forwarded to them to get them to take another look at my case, and they have finally fixed their missing PVC. Thanks again.Matthew
I have moved the fiber on the ls1010 from atm0/0/0 to atm0/0/3 and adjusted the configuration to reflect. I still am unable to pass data between data between the atm0/0/3 on the light stream and atm0.3 on the 4700. I cleared all counters and checke...
