Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
--begin ciscomoderator note-- The following post has been edited to remove potentially confidential information. Please refrain from posting confidential information on the site to reduce security risks to your network. -- end ciscomoderator note -- ...
I've set up 2 3640's for dial backup.When R1 Serial Int goes down, Dialer comes up, Dials via BRI to R2. Connection establishes, Authenticates (CHAP) normally, but I can't ping R2 from R1 or Visa Versa. Anyone have any ideas?
I've set up 2 3640's for dial backup.When R1 Serial Int goes down, Dialer comes up, Dials via BRI to R2. Connection establishes, Authenticates (CHAP) normally, but I can't ping R2 from R1 or Visa Versa. Anyone have any ideas?
I'm wondering if anyone else is having or seen this problem and what might cause it.When users VPN in over their Wireless Router, Connecting through their DSL Router doing NAT, They can't connect to any internal resouces. WWW is still fine but nothin...
I have a 2600 that will not respond via the console port at allI'm using Win2K / Hyperyterm9600, 8, N, 1tried both com portstried 2 different systemstried new cable and connectorAnyone have any other ideas?
I'm not sure I understand this correctly.If I plug the console cable in R1 (I assume router 1?) and the other end into the console port of R2, I can do a reverse telnet? That might be ok if the routers were right next to eachother, unfortunately the ...
What about doing authentication the other way around? would that be possible? ie; have the dialup users authenticate first to radius server since this would be the first priority and also have the remote router dial into the same interface, not be ab...
So if I would like the remote office router to authenticate locally given the above commands, would it cause the existing radius authentication to fail?Thanks, ---Mike
Thanks for the Authentication Information.A few other questions that I have are: Instead of using the Radius Server to authenticate, can I use the HQ 3640 Router instead? If so, how?If The primary link comes back up, will the ISDN call then drop on i...
Mark,Thanks for the link. So would it be possible to configure the Oregon router and the radius server (HQ side) with a username and password to authenticate on dial up?If so, which interface should the username and password be configured on?Would th...
