Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi I have a Aironet 350 point to point wireless bridge. It will operate at 10Mb/s half duplex. What is the maximum data throuput that I can achieve I have been quoted a figure of 3.4Mb/s? Is there any general documentation that can help me?
I am trying to work out how to correctly contend my Internet customers. Each of their circuits is presented by a VLAN. I have tried access lists but the big problem is that as some customers have more IP addresses than others and so some get more of ...
Hi I have a E3 ATM Module on a 3745 router and a E3 Serial Port Adapter on a 7206 router. Is there any possibility that i can use the ATM E3 interface as a serial port adapter and so get the two interfaces to talk to one another and pass traffic.reg...
HelloCan i run a PIX 501 to PIX 506 IPSec VPN thru a NATted network.My ISP presents me with private IP addresses that are statically NAT'd to a public IP address t location A. At loctaion B I have standard Public IP address. Is an IPSec VPN possib...
Are there any problems running BGP over a BT LES100 Circuit?I have been told conflicting things by different ISPS, I assume there id no problem as if one end of the link dies and one stays up that TCP will be dropped and thus down UDP 179 instantanio...
Thanks for the documents but this doesnt actually work as I need to be able to set the CAR per customer VLAn and then contend say for example 10 customer VLANs in a contention group.
Regarding Remote or Site-to-site, we have numerous prospective customers and so need to know what we can exactly do! We want to be able to do both if possible!
