About djones

djones · 02-22-2008

The Cisco docs talk about needing to be at a 7.2 version before upgrading to 8.0.x. However, I haven't really found a reason why that is.I went into my lab and put the same version that my production ASA is running and dropped the same config on it....

djones · 02-02-2007

Studying for BSCI and I ran across the option of adding 'permanent' to a static route. It says that with this option, a static route will stay in the routing table even if the interface it's related to goes down.However, what I can't figure out is w...

djones · 07-02-2008

I'm running 8.0.3 in production and it's consuming 36%. No issues so far. It's been about 2 months.

djones · 02-04-2008

I have this on mine:username xxxx password xxxx encrypted privilege 15

djones · 02-04-2008

Create an acl with the networks/hosts you want to be able to access it, then use the command:'ip http access-class #'

djones · 02-01-2008

No, it doesn't list the Windows firewall specifically but does allow you to configure some custom properties (see attached).Also, keep in mind that unless you're doing split tunneling, the firewall doesn't add that much more value (I would argue agai...

djones · 02-01-2008

Make sure the pc isn't using Fast User Switching. If they switch over from another user on the pc, it won't work. The other users on the pc need to be logged off or it won't work. This goes for older clients too.

Member Since	‎06-24-2002 12:07 PM
Date Last Visited	‎08-18-2017 03:51 AM
Posts	20

User Statistics

User Activity

ASA 7.0x upgrade to 8.0.3

Static route with 'permanent'

Re: ASA5540 with Version 8.0.3

Re: Error Configuring ASA with ASDM

Re: SDM access

Re: VPN Concentrators Replaced?

Re: Windows Vista and VPN Client 5.0