Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Original problem was not being able to import or add new users in Unity - and there were no servers or mailstores listed in the add new subscribers page. Tried to resolve by reconnecting to mail server. Ran configuration setup and disconnected form...
I am at the end of the CRS 3.02 install, and it has been hung at 98% (it's about where the bar is...) for about 3 hours now. The text says "performing SpanLink install", and it is counting down saying there's about 20 minutes left. When it started,...
One of our customers is having a problem that should be easily fixed - I just can't seem to find the right place to look. When doing the "Find" function on any of the pages, such as "Devices" or "Gateways" the customer reports that the bottom frame ...
I am trying to use a AIR-AP1220B-A-K9 for a site survey. There is no LAN access for the AP's yet, so the AP does not get a Link. Because of that, the AP tries to switch to repeater mode, and so I cannot associate to it.I've looked all through the w...
I am rebuilding a Unity 4.0(1) server after an AD Forest was replaced, and need to be able to remove subscriber properties from the previous 4.0(1) installation.I have GSM installed, but of course, since Unity isn't actually installed, I can't connec...
I can start them before I run configuration setup - however, during configuration setup, they are stopped when it stops the rest of the services. I'm not sure if this behavior is normal, but that's what happens.If they are started when the configura...
Jeff,I sent the message without completing the thought. I'm importin the users into 4.0(1) and have looked at the Bulk Import Exchange tool, but the drawback is that the .csv has users spread across 5 different OU's, while the tool only allows you t...
