Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
What is the order of operation for PBR and "ip tcp adjust-mss."I have two ISP's (i.e. 2 default routes) and need to force pbr matched packets to use one ISP. When PBR is configured on the routers ingress interface, I get web browsing behavior that ...
I am trying to staticly load balance between two ISP's. One connection is Ethernet the other DSL. My route statements are as followsip route 0.0.0.0 0.0.0.0 dialer 0ip route 0.0.0.0 0.0.0.0 63.45.61.161show ip route 0.0.0.0 Routing entry for 0.0.0....
I am interested in setting up a repeated wireless network using an 851w and an 1121. The documentation for the 1121 specifically discusses repeater mode. The 851w documentation doesn't specifiaclly talk about repeater mode but it does have the comm...
Im trying to set a a policy route on a VLAN interface on a 3750 running 12.2.25(SEE) advanced.After entering the vlan interface I type:ip policy route-map pbrI get no complaints but the line doesn't show up in the config. What am I missing? Does th...
I am trying to enable 802.1x to get guests into a guest VLAN. These guest should be able to accomplish this without any assistance from tech staff.Unfortunately, I can't get this to work. By default, Windows XP is configured with 802.1x enabled us...
Assuming this configuration is on a switch, Dot1x is disabled by default on each interface (dot1x port-control force-authorized) so enabling dot1x globally without setting "dot1x port-control auto" effectively does nothing. Maybe someone configured ...
Connections over the link work fine until I enable PBR. Once PBR is enabled, I get partial page loads on some websites as if the adjust is not set. I haven't put a sniffer on it yet but it really looks like the adjust isn't happening. Do you have ...
You may have been confused by the fact that this website removes extra spaces. Please view the route to 0.0.0.0 as ...S* 0.0.0.0/0 [1/0] via 63.45.61.161 -------------is directly connected, Dialer0You will notice my original post shows the configure...
Gateway of last resort is 63.45.61.161 to network 0.0.0.0 63.0.0.0/29 is subnetted, 1 subnetsC 63.45.61.160 is directly connected, FastEthernet0/0 192.168.10.0/32 is subnetted, 2 subnetsC 192.168.10.251 is directly connected, Dial...
Are you aware of which "cisco specific feature" will not be supported if I have a non ccx device associated to a repeated network? I need to make sure my clients will be able to associate. Also, do you know which version of ccx is required for repe...
