Hi Team,
I have an environment set up pretty similar to the diagram below; (recreated in the lab for testing);
There are 3 routers (ROUTER1, ROUTER2, ROUTER3), and 2 Firewalls (FIREWALL1, FIREWALL2)
Interface G4 on ROUTER1 and ROUTER2 is in a ...
Hi Everyone.
I have a tcl script that automatically writes the running config off to a TFTP server if a user enters and then exits the configuration mode on a device; as per below;
::cisco::eem::event_register_syslog occurs 1 pattern .*%SYS-5-...
Yes - that was to try an manipulate it.. I left one of the "0's" off the delay value.. the delay should read 100000, to try and cost it higher..
This had no impact to the route selection.. It still went via the EIGRP path, rather than the shorter ...
Thanks Joe,
I can see the way to write the applet to trigger on the event that the syslog message;
%SYS-5-CONFIG_I
is logged.. but what would be the best way to ignore the events that are triggered by the user logging in as the software-account? as...