About rguerra

rguerra · 12-10-2002

I have 2 SUPIis PFC2swith MSFC2s. CATos 7.4.2 MSFC 12.1(12c)E2. I have a router connected to a port and is a directly connected route. When failover of the MSFC occurs, I can ping from the newly active MSFC to the directly connected route until th...

rguerra · 12-17-2002

If you think it is a MAC issue, you can use the STANDBY USE-BIA on both HSRP routers to use the real MAC of the interface instead of the virtual MAC which floats between the HSRP routers. Also, be careful of the priority of standby router. If you u...

rguerra · 12-17-2002

You have to have at least one port active in the vlan for the vlan interface to be up/up. When you break the 6509s, the only pirt in the vlan goes down, so the vlan goes down. Try assigning a few ports in the vlans and have them come up. When you ...

rguerra · 12-10-2002

If you followed the instructions from the Cisco site, you changed the console baud rate. This is why you see cryptic characters. Check your settings in hyperterm and change the baud rate until you see characters which you can read. Also, XModem ta...

rguerra · 12-10-2002

I have experienced this exact problem about 2 years ago The stated access list works and is what we implemented. Also you may experience this issue with 2 6509s and 4 MSFCs. Try running Single Router Mode on the MSFCs.

Member Since	‎07-01-2002 08:47 AM
Date Last Visited	‎08-18-2017 03:51 AM
Posts	7

User Statistics

User Activity

CEF problem w/ MSFC failover

Re: HSRP problem

Re: HSRP strange problem

Re: Flash Memory Recovery

Re: The duplicate address on hsrp group.