Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a Customer who currently uses CNR and I need to investigate an alternative platform. It currently runs on AIX, which is going out of support later this year.I am looking to get some information: -o Which platform is typically used in the marke...
I have two Cisco 1200 Access Points (A & B)with 802.11b radio’s attached to two separate Cisco 4006 switches in a Comms room. AP A is located in one room and AP B in another. The APs are in-line powered from the switches. WLAN has been secured using ...
I have a 5505 with RSM & TR Modules which I want to connect to a 6509 Switch. Can anyone provide initial steps in configuring the 5505 to talk to the 6509 when the uplinks become active. TRSw will be on the 5505 with Switched Ethernet on the 6509. FY...
Are there any design guidelines or known problems within a WLAN when using a DECT Phone within the same coverage area as Wireless in terms of do's & don'ts and frequency 'black holes'?
I have quoted (2x) PWR-C45-2800ACV, Catalyst 4500 2800W AC PowerSupplies for each of my 4506 boxesThese PSU require the CAB-AC-2800W-INT international power cord and areterminated at ground level not by the traditional 3-pin plug (UK) but the roundco...
Using Cisco's Fast EtherChannel technology, you can scale your network from 3 units (48/56-port stack) to 5 units (96/104-port stack) and with the StackPack it provides up to 1.6 Gbps of aggregate bandwidth between switches. We have implemented this ...
Thanks for the URL. We do not enable host ports on any switch. The CatOS is 6.2(3) and we see excessive Rcv-Err, Single-Col, Multi-Coll and Excess-Coll, resulting in a proliferation of runts. This in turn presents an inordinate amount of "In-Lost" pa...
