Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
My question is a simple question ... I believe, but I can't find an answer.Is the 4500 chassis completely passive or are there inside it any active component?This question is in order to decide right redundancy and provisioning spare part policy.Than...
Hello,I need to upgrade a Catalyst 4006 from CatOS to IOS.I have some doubt.Is it possible? Wich are the rquirements? Wich is the procedure? Any issues?Thanks in advanceEnrico
I have to access to a VPN 3000 concentrator in order to configure it for my network.The VPN3K is not new, it was runnning in the past inside the company but no one knows any info about configuration and so on. I don't know not even the ip address.Try...
Strange problem.From the Pix I can't ping and I can't reach pc or device on the inside interface of the Pix.From the pc on the inside interface I can manage the Pix, ping it and so on.In attachment the configuration.Any help would be appreciated.Than...
I have to replace a Cisco 3660 with the NM-4E1-IMA module with a Cisco 3725 with the AIM-ATM-4E1 bundle, on the same ATM link.Using the same configuration of the 3660 router and using the necessary "mode atm aim 1" command into the controllers E1 0/0...
Hello Raj.I have tried with the hoding the reset button down during a reboot, trying to press it for a few seconds, but nothing change.The cable is a classic cisco blue cable with two adapters but I have no output from the hyperterminal serial connec...
Thank you very much for your help.I think the to have solved my problem adding in my configuration the clock commands (network-clock-select 1 E1 0/0) and enabling the scrambling, as you suggest.CiaoEnrico
Thank you Daniel,but the problem is that I have to change a Cisco 3660 with the NM-4E1-IMA module with a Cisco 3725 with the AIM-ATM-4E1 bundle.Using the same configuration of the 3660 router and using the necessary "mode atm aim 1" command into the ...
