Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
This seems to be a common theme, but none of the other posts are exactly like mine.I have 4 VPN software clients (different versions) that can connect to a VPN Concentrator 3005. 2 clients work fine, they connect and can ping the server. I have two...
I know there is a procedure to force an IP address of a remote router's serial interface over a serial link, but what is the protocol's name or steps to do it? Say you have a serial link that's up/down because the remote router's interface is not ad...
I know there is a procedure to force an IP address of a remote router's serial interface over a serial link, but what is the protocol's name or steps to do it? Say you have a serial link that's up/down because the remote router's interface is not ad...
I have a single UR PIX 515e running 6.3.3 in production. I'm adding a FO PIX 515e but it's running 6.3.1. I tried to add an IP address to the new FO PIX, it accepted the configuration and the inside interface got a link with my laptop. But TFTP an...
I'm using CSACS v3.1 for Windows and several Cisco switches, routers and a PIX.Below is the AAA config I'm using on the NASs. It works great if I telnet to the NAS, (I get a Username/PW prompt, and drop into "Privledged Mode") If I Console into the...
No existing connectively. You have a serial link but you can't telnet to the remote router though it because their is no IP address on the remote side. There is a way to force an IP address across the serial link so you can then telnet to the remot...
Thanks! I didn't have to do that. The problem was the FO PIX needed to be made active. One of the messages above was correct "failover active" and the FO PIX started passing traffic.THANKS! to all
