Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello , TeamThe XXX.XXX.2.XXX bandwith is divided into 1-127 and 128-254.A server ip - XXX.XXX.2.139.The B server has two IPs. (one- VIP:XXX.XXX.2.32 , Real IP-XXX.XXX.2.141)-A server can connect ssh and sftp to B server Real IP.-Within the local L4 ...
Hi
I upgraded the firmware of UCS(C240 M3) from 1.5.3 to 2.0.4c using HUU.
Most of the server was finished completely but one server was failed.
So I booted the HUU again but the 2 NIC card are missed in the list.
Therefore the firmware of the NIC ...
Hi there,
I plan to implement 802.1X authentication with VLAN assignment on our network and assign different VLAN onto the access switch(Cat2960) according to end devices (for example, VLAN10 for WLAN, VLAN20 for voice, VLA30 for IPTV set-top box,...
Hi Javier,
Thank you for your answer.
That mean I can enable 802.1X ports, excepting trunk port on switch-B to which end user is connected.
And 802.1X traffic(EAP) can pass though trunk port on Switch-B
Is it correct?
Hi Javier,
My understanding for your comment is that I can't use (L2 Switch) <--> (L2 Switch) <--> End-devices and the only possible topology is (L2 Switch) <--> End-devices.
Is it correct?
How about this topology?
(L2 Switch-A) Port #1 <-----...
