Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
One of our client has reported that his Mac G5 is dropping out of the network after 10 minutes of initial connection from Cisco 4506 switch. But the same G5 could connect to Catalyst 6509 switch with CatOS(7.6) and it works fine (no network drops). I...
We have recently installed 10/100/1000 line cards in Catalyst 6509 with Cat OS. I am hearing reports that the clients have problems connecting at gigabit. I have done some research into gigabit connectivity and I found that autonegotion in gigabit co...
Hello,I would like to know the difference in implementation of the both operating system(CatOS and integrated IOS) in Cisco 6509. While deploying 6509 as a layer 2 device only with CatOS one need a sup II module but the same thing does not apply when...
I would appreciate the feedback for the following messages in wireless APRadio Enable Failed with error "Bad Authentication Type". Temporarily Disabling WEP Encryption and re-Attempting Enable. THIS ERROR MAY INDICATE TAMPERING WITH THE RADIO AND/OR ...
Hello All,After my research, we thought of upgrading the switch software to version 12.1(19)EW1 and this fixed the problem. It is really strange and I thought of sharing this information with the forum. I think some times upgrading the switch softwar...
I do not this so. Also we have not enabled any flow control on this interface. This 10/100/100TX copper gigabit port. Also show int gig x/y shows normal output. No error disable on the port.Thanks again for the feedback. I would post to this forum if...
We set the speed to 1000Megabit for both the switch port and G5 manually. Also the same switch port was on autonegotiaion on both ends. Please note that this may not be spanning tree issue because the G5 connects to the network when it boots up and d...
Current configuration : 124 bytes!interface GigabitEthernet2/4 switchport access vlan x(removed the vlan #) switchport mode access speed 1000 spanning-tree portfastendwhat does the command switchport host would do. Is it the same as set port host com...
