Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hi please follow below link SSID-on-Autonomous-AP-Configuration-Examplehttps://www.cisco.com/c/en/us/support/docs/interfaces-modules/security-modules-routers-switches/116586-config-ap-00.html
dont know you are still looking for answerhe switching forwarding rate= ports number × corresponding packet forwarding rate of ports.The packet forwarding rate for gigabit port=1,000,000,000bps/8bit/（64＋8＋12）byte=1,488,095ppsPps is short for packets ...
dont know whether u r still facing this issue .u can change line and port setting to below . ip host S1 2002 1.1.1.1ip host S2 2003 1.1.1.1ip host S3 2004 1.1.1.1ip host S4 2005 1.1.1.1ip host R2 2006 1.1.1.1ip host R3 2007 1.1.1.1ip host R4 2008 1.1...
stack is in active /standby state only . as per show switch detail commandif you turn off active switch . standby wil become active and works fine ..rate if helpful.
