Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are trying to configure a serial interface in X25. Our X25 subscription specifies that SVC 0 is used. All the X25 CISCO commands to configure the SVC range start with SVC 1, how is possible to configure the cisco in order to us...
Dear Sirs,my 7500 reports the following notice:Jul 10 20:07:41: %CIP2-0-MSG: slot1 %CTA-0-INACTIVE: PA0 CTA C510-10reset after being inactive for 180 secondswhich, according to the doc is a problem on the host (see below).Does anyone know a command t...
In the document "Cisco 7200 Series Port Adapter Hardware Configuration Guidelines" I didn't find the Bandwidth value for the PA-4C-E ?The only value mentionned on that document is for the Adapter PA-1C-E. Which is 100 for this adapter.Can somebody te...
I finally found the command !!! "x25 subscribe lc0 two-way" It seems to solve the problem. But I do not understand why there are such masked commands. ...
Thanks to all for your answers!I already check all recommandations described in the document referenced forthe NIC compatibility issues.... all these tests ended badly. There was a little gain with the parameter carrier-delay set to 4 but still the l...
