We have a Bri configure using switch type basic-net3 with a debug q921 we see the lin up and multiple-frame -established, we see 6 rr cross the link, then we receive a dsicp from the Telco. We are being told that this is due to the exchange we are co...

Trace route to x.229.239.7 (x.x.239.7) 1 (x.x.36.254) 3 ms 2 ms 3 ms 2 (x.x.197.25) 3 ms 3 ms 4 ms 3 (x.x.197.6) 2 ms 3 ms 3 ms 4 (x.x.197.62) 3 ms 4 ms 4 ms 5 (x.x.x.x) 6 ms...

I have two devices attached via token ring with a wan in the middle.I see circuit established between devices at both ends but not to one device never goes into session.show dlsw circIndex local addr(lsap) remote addr(dsap) state ...

We have a cisco 1603 router using dlsw+ to peer with a Nortel ASN.at the cisco end it is x21 connection from the FEPat the Nortel end it is token ring to an OSAwhen we try and start a JES node we get an IBM sense code 800A0000 and the session drops.T...

I have a number of stun channels which went showed as dead in the statefield. When using the command "show stun"Is there any documentation showing what would cause this.at the remote end of the link the router was showing state as "open"at the FEP en...