Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a Cat4006 Sup-III with the following as a show version:Cisco Internetwork Operating System SoftwareIOS (tm) Catalyst 4000 L3 Switch Software (cat4000-IS-M), Version 12.1(8a)EW1, EARLY DEPLOYMENT RELEASE SOFTWARE (fc1)TAC Support: http://www.ci...
I have some clients that use an app that has historically had a "route add" statement in their client config., directly on the PC that is. This is in addition to the default gateway that is acquired via their DHCP server. I should be able to add t...
Has anyone done QoS on this box not related to VOIP? I have some low-res video req's for a media house. I'm wondering how to, if needed, configure QoS to ensure the video traffic is not impeded.thanks
I posted a msg on the VPN post about a month ago, but did not get resolution.I need to find out how to reset the password on the vpn3005 WEB Interface, not the command line interface. I have done a passowrd reset procedure. This ONLY resets the com...
Yes all clients are using the same def gw to get to the internet. I have a statement of "ip defalut-gateway ip-address". The clients are configured to use the def gw of thier VLAN. This is a CAT4006 w/SUP-III so its IOS.
The different VLAN's are in effect separate segments, subnets and broadcast domains, I have the same setup but with Catalyst 4006's.You must allow helper addresses on each VLAN AND you MUST allow UDP netbios ports. The helper address is the address ...
Are you running a Supervisor-II or Supervisor-III engine in the Cat4006? If you are running the Sup-III, broadcast suppression(containment) is accomplished by setting up VLANs on the switch, adding switch ports to the VLANS, which become smaller, mo...
I have 3 Cat4ks, One is Sup-3, 2 are Sup-2s. The CatOS is 7.2(1) on the Sup-2's. I have Not seen this. Are any of you running VTP for your VLAN updates?I have VTP configured. The Sup-3 box is the VTP server, the SUp-2's(and a single 3550) are VTP...
