Hello I am using ISE 2.6 in a VM setup. I have two interfaces:G0: Meant to be for management purpose to login to the UIG2: Exposed to the network where Radius AAA requests incoming. Its a requirement to use this G2 interface only and not respond to t...
Hi anyone from Cisco product development side,I would like to know what is the path Cisco is adopting in L2 VPNs. I know martini draft is something that's available today, any plans for p-to-multi point L2 VPNs,
@MHM Cisco World Thanks - that was the issue. When I flipped back and forth I didn't change the IP of the NAD in the ISE. Once I corrected auth started working. Thanks for the pointer.
Yes, I am able to ping the G2 interface (stated earlier too) from the NAD as well as the Client. G0 is on a different network for VM-NET-MGMT (for management purpose only i.e. for users to login to ISE etc..). The G2 is on a different Network that co...
Sorry Rob - was outside yesterday. If its a NAD issue that it should not work on when using the G0 interface. I tried re-adding the NAD type and attributes but no luck.To your earlier question - the tcpdump shows the incoming request to the ISE on th...
Yes Rob. I see the radius requests coming in. See attached a snapshot.You've mentioned about a possible bug - I have this patch applied: ise-patchbundle-2.6.0.156-Patch10-21081000.SPA.x86_64.tar.gzHere is the livelog:Steps 11001Received RADIUS Access...
Yes all those basic config is not an issue. Just to add to what tests we ran another test here: I moved one of the NADs to a different network which can reach the G0 interface (even though its not allowed by policy but for testing purpose I managed t...