Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Could anyone can assist in policy route map? I would like to apply the ip policy route map in VLAN300. Below, you see the port interfaces and static routes in switch as well as Router A & B. I would like have an “access list” for Vlan300 to rou...
HiCould anyone let me know whether each vlan can define 2 ip helper-address ? Example below which i have this existing vlan in Switch:- interface Vlan100 ip address 172.30.49.254 255.255.254.0 ip helper-address 172.30.48.5 no ip redirects ntp...
A new challenge for me which our organization is going to rollup MS TEAMS very soon. However, I stuck those requirements how to apply QOS in our L3 switches that requested by our voice vendor as below:-Voice, Video and File sharing traffic originatin...
Hi
Today I have a problem with ASA5505 which I can't access via ASDM. The error show "ASDM did not get a response from the ASA in the last 60 seconds. Please check the configuration and your connection and then try again by clicking refresh". I cou...
Hi
I tried to delete the red line as below using CLI command.. But I put a "no" in front as follows:- It said Error: %invalid Hostname. Anyone please enlighten me?
Thanks
ASA(config)# no access-list internal.in line 4 extended permit tcp 172.30.4...
Hi The 172.30.51.210/23 (vlan300) traffic go through router B for RFC1918 traffic which the static routes are correct. The problem is 172.30.51.210/23 will be going to interface Gig3/0/2 for Non-RFC1918, which i want it to go to interface Gig3/0/3 .....
Hi See below:- Do you think auto QoS is really help ? I read through some Cisco forums with regards auto QoS , sometimes it doesn't fit into the organisation as those people comments. Have your organisation use AutoQoS? If so, how is the performance...
Thanks for your reply, Deepak. As below is a test configuration which i am trying.As said that PC softphone has a DSCP value of 46 (EF) for Audio, DSCP value of 34 (AF41) for PC video and DSCP value of 18 (AF21) for PC screensharing. All have been re...
Paul
Thanks for your respond. This is a new switch. Do I need to configure the Switch SDM template by issue a command #sdm prefer lanbase-routing? As I know those old model Cisco 2960s need to enable the lanbase routing. Hope to hearing from you ...