Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have three point-to-point T1s between two locations. They are connected to a 4 port IMA card which sits on a 3660 on each side. The problem is that all 3 T1s show up in the group, but the traffic never goes over 2.667Mbps. Is there an issue. Here ...
I have turned on OSPF on the PIX. I have two different areas - 100 on the outside and area 0 on the inside. But, the routes from the inside are showing on the dmz routers. Is there any command on the pix to stop you from doing this?
Eventually found the problem thanks. There is a bug in the code. You have to remove the ATM IMA configuration from the router and re-apply it. You have to do this every time you add a new T1 to the group. It sucks, but you have to play the game I sup...
HI, Thanks for the config. It is something to what I was looking for. I am having a little difficulty understanding how the filter list makes the inside area an ABR. In my network the situation is reveresed. I have area 0 which is on the inside, and ...
