Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
i configure aaa on my switch and cannog get telnet loggin. in the PAsst Athem ACS Server: Authentication is OK, but FailItem Unknown NASThanks for any Help-----------------------------------------aaa new-modelaaa authentication login default group ra...
i configure port security mac-address sticky on a cat6500, but i cann hit the global command " clear port-security sticky interface nr access" Thanks for any responseAlain
Hello Voice Guruplease help me to solve this problem. my Topology look like this:Phone -- PBX -- E1 qsig -- c3640 -- h323 -- c7206 -- E1 qsig -- PBX -- PhoneThe problem is that I can manually dial from phone to phone, but if you use the redial featur...
Hello Mngt GurusI am loocking for a Monitor product for my customer network and wann to know what better between Nagios and WhatsUp gold. cann someone help me a give me some difference for both product ThanksAlain
Hello Georga) only access to "internet" and to the VLAN "Shared Services" --> who should be able to access the Internet and the VLAN "Shared Services" ? YESb) Vlan restricting communikation between VLANs --> do you want to configure a VACL so that no...
Router1 Fa0/1-- L2 Switch --PIX1 (yes)Router2 Fa0/1-- L2 Switch --PIX2 (yes)Same way while conecting Fa0/0 towards ISP routers. (yes) (Here L2 switch only one Switch) (yes)Also are you using PIX in redundant mode (yes)
Hello Scott,Thanks for yopur replay. At the moment i have a statefull failover with a dedicated serial cable and an crossover cable connected to both PIXs. My problem is: sometimes ( min. One time a week) the Pix is making an unnecessary failover and...
Hello Robert,thanks for your replay ! just to say that i solve the problem : since i configure the ip pim in Vlan 300 where my Ghost server is located.ThanksAFE
