I have changed the access point name in controller and it shows two access point names , the one i have changed and the previous existing one. what behavior is this ?before changing : SW01#sh cdp neiCapability Codes: R - Router, T - Trans Bridge...
A new access point is replaced and dhcp is leased from firewall . But the access point gets the mac as name in cdp neighbors, what behavior is this ? SW01#sh cdp nei det-------------------------Device ID: AP500F.8049.FED0Entry address(es):IP address...
before port 1 bouncing or changinng power inline config :gggSW1#sh cable tdr interface Gi 0/1TDR test last run on: July 01 13:34:35Interface Speed Local pair Pair length Remote pair Pair status--------- ----- ---------- ------------------ -----------...
yes @Richard Burts , just after 5 minutes , i have checked and now i am not seeing the old entry. Now everything looks good.Thanks @Joseph W. Doherty @Martin L @Richard Burts , You guys are really helpful to young engineers like me..........it...
HI @Reza Sharifi now i am seeing it got the right host name from controller , but for some period of time it shows the mac address as host name , did not understand what behavior is this
Hi All . @Leo Laohoo @balaji.bandi @paul driver .I have the moved the access point to port 2 on the switch , now everything looks good.Thanks for the quick inputs. You guys are really great in helping the community.